Blar i SINTEF Open på tittel
Viser treff 772-791 av 10059
-
Attaining a higher flexibility degree in CO2 compressor racks
(Science et technique du froid;, Chapter, 2020)CO2 compressor racks have shown their suitability for commercial and industrial refrigeration systems at any location and climate. Even if some references state that CO2 units can compete in capital cost with any other ... -
Attaining Low Lattice Thermal Conductivity in Half-Heusler Sublattice Solid Solutions: Which Substitution Site Is Most Effective?
(Peer reviewed; Journal article, 2022)Low thermal conductivity is an important materials property for thermoelectricity. The lattice thermal conductivity (LTC) can be reduced by introducing sublattice disorder through partial isovalent substitution. Yet, ... -
An Attempt to Estimate the Sulfuric Acid Dewpoint in the Flue Gas from Aluminium Electrolysis Cells
(Peer reviewed; Journal article, 2022)The sulfuric acid dew point in the flue gas from aluminium electrolysis cells increases with increasing concentrations of sulfur dioxide and water vapour. This represents a potential problem in a future scenario with reduced ... -
Attitudes and perceptions about becoming a prosumer : results from a survey among Norwegian Residential customers - 2016
(SINTEF Rapport;2017:00078, Research report, 2017) -
Attitudes in Norwegian insurance companies towards sharing loss data – Public-private cooperation for improved climate adaptation
(Klima 2050 Report;11, Research report, 2018)Background and research questions Research has shown that loss data on asset level from insurance companies have high utility value for local municipalities. These data can foster better understanding of the risks linked ... -
Audio augmented reality in public transport for exploring tourist sites
(Chapter, 2018)Audio augmented reality (AR) has a long research tradition in the tourism industry. Audio AR tour guides for urban environments provide location-based, auditory information about nearby sights, minimising distractions from ... -
Augmented Reality and Virtual Reality for Retail Innovation
(Journal article; Peer reviewed, 2018)Nye og bedre Augmented Reality (AR) og Virtual Reality (VR) applikasjoner utvikles helle tiden og brukes mer og mer i handel. Utvikling i AR and VR i løpet av de siste årene satt i gang mange innovasjoner i måten handelen ... -
Augmenting the Production Operators for Continuous Improvement
(Chapter, 2022)This paper discusses how continuous improvement activities can be supported by augmenting the operators in production. After a brief literature background, real life case examples from manufacturing companies are provided ... -
The AutoActive Research Environment
(Peer reviewed; Journal article, 2022)ARE consists of three different software modules; ActivityPresenter, a Matlab toolbox, and a Python toolbox. ActivityPresenter is created to simplify the process of visualising, synchronising, and organising data, such as ... -
AutoConf: Automated Configuration of Unsupervised Learning Systems using Metamorphic Testing and Bayesian Optimization
(Chapter, 2023)Unsupervised learning systems using clustering have gained significant attention for numerous applications due to their unique ability to discover patterns and structures in large unlabeled datasets. However, their ... -
Autogenous deformation and relative humidity - Concrete with Aalborg Portland cement and fly ash
(COIN Project report;24, Research report, 2010)This report summarizes the results from a series of experiments carried out in 7 new dilations rigs measuring autogenous deformation in concrete. The intention was to find a relation between autogenous deformation and ... -
AutomAl 6000: Semi-automatic structural labelling of HAADF-STEM images of precipitates in Al–Mg–Si(–Cu) alloys
(Peer reviewed; Journal article, 2022)When the Al–Mg–Si(–Cu) alloy system is subjected to age hardening, different types of precipitates nucleate depending on the composition and thermomechanical treatment. The main hardening precipitates extend as needles, ... -
Automated 3D burr detection in cast manufacturing using sparse convolutional neural networks
(Peer reviewed; Journal article, 2022)For automating deburring of cast parts, this paper proposes a general method for estimating burr height using 3D vision sensor that is robust to missing data in the scans and sensor noise. Specifically, we present a novel ... -
Automated Detection of Electric Vehicles in Hourly Smart Meter Data
(Journal article; Peer reviewed, 2019)Automated detection of EVs from smart meter data can provide important insights for DSOs about spatiotemporal EV charging patterns. However, smart meters typically provide only hourly measurements of consumption while most ... -
Automated morphometrics on microscopy images of Atlantic cod larvae using Mask R-CNN and classical machine vision techniques
(Peer reviewed; Journal article, 2022)Measurements of morphometrical parameters on i.e., fish larvae are useful for assessing the quality and condition of the specimen in environmental research or optimal growth in the cultivation industry. Manually acquiring ... -
Automated Multi-Skill Shift Design for Hospitals
(Journal article; Peer reviewed, 2010)For labour intensive organizations, finding a good match between the predicted workload and the scheduled workforce work capacity is crucial: One important step in this matching process is shift design and it have received ... -
Automated shuttle services in public transport. Lessons learned from the smart feeder research project in Norway
(Conference object, 2020)Backround. Automated mobility services hold a potential to change the way transport is performed, giving rise to previously unknown possibilities, but also new challenges as well. The technology push is significant, as the ... -
Automated System for Fleet Benchmarking and Assessment of Technical Condition
(ASME Proceedings | Ocean Engineering;OMAE2017-61219, Chapter, 2017-06-25)On-board Energy systems in vessels have to use fuel efficiently to maintain ship speed at lowest possible costs. This paper describes how to use ship operational data to improve and maintain efficiency of the vessel’s power ... -
Automated tracking of cell migration in phase contrast images with CellTraxx
(Peer reviewed; Journal article, 2023)The ability of cells to move and migrate is required during development, but also in the adult in processes such as wound healing and immune responses. In addition, cancer cells exploit the cells’ ability to migrate and ... -
Automatic Classification of Sub-Techniques in Classical Cross-Country Skiing Using a Machine Learning Algorithm on Micro-Sensor Data
(Journal article; Peer reviewed, 2018)The automatic classification of sub-techniques in classical cross-country skiing provides unique possibilities for analyzing the biomechanical aspects of outdoor skiing. This is currently possible due to the miniaturization ...