Blar i SINTEF Open på tittel
Viser treff 5553-5572 av 10067
-
Measurements to Estimate the Downward Heat Flux from a Burning Oil Pool
(Chapter, 2018)Oil spills in ice-covered waters pose unique challenges to remediation activities. In-situ burning is a potential remediation technique that has shown promising efficiency in earlier trials. An element of in-situ burning ... -
Measures against hydrocarbon leaks: taxonomy, effect and costs. A literature study of measures against hydrocarbon leaks.
(SINTEF Rapport;A28119, Research report, 2017) -
Measures and scenario studies for emission reduction : CenSES review
(SINTEF Energi. Rapport;TR A7602, Research report, 2016-03-01) -
Measuring Disability and Inclusion in relation to the 2030 Agenda on Sustainable Development
(Journal article; Peer reviewed, 2017) -
Measuring In Situ Interfacial Contact Resistance in a Proton Exchange Membrane Fuel Cell
(Peer reviewed; Journal article, 2019)Interfacial contact resistance (ICR) is one of the remaining hurdles for successful implementation of stainless steel bipolar plates in PEM fuel cells. We have developed a reliable method, using thin gold wires, to measure ... -
Measuring particle concentration of multimodal synthetic reference materials and extracellular vesicles with orthogonal techniques: Who is up to the challenge?
(Peer reviewed; Journal article, 2021)The measurement of physicochemical properties of polydisperse complex biological samples, for example, extracellular vesicles, is critical to assess their quality, for example, resulting from their production and isolation ... -
Measuring particle size distribution and mass concentration of nanoplastics and microplastics: addressing some analytical challenges in the sub-micron size range
(Peer reviewed; Journal article, 2021)HYPOTHESIS:The implementation of the proposal from the European Chemical Agency (ECHA) to restrict the use of nanoplastics (NP) and microplastics (MP) in consumer products will require reliable methods to perform size and ... -
Measuring Self-Reported Access to Assistive Technology Using the WHO Rapid Assistive Technology Assessment (rATA) Questionnaire: Protocol for a Multi-Country Study
(Peer reviewed; Journal article, 2021)In 2018, the World Health Assembly adopted a resolution on improving access to assistive technology (AT), and mandated the WHO to prepare a global report on assistive technology based on the best available evidence and ... -
Measuring the Impact of Environmental Constraints on Hydropower Flexibility
(International Conference on the European Energy Market;18, Chapter; Peer reviewed, 2022)Implementation of EU’s Water Framework directive, meant to ensure sustainability of the hydropower production, may lead to new environmental constraints on hydropower systems. This can result in loss of production, reduced ... -
Measuring the level of compulsory hospitalisation in mental health care: The performance of different measures across areas and over time
(Peer reviewed; Journal article, 2021)Objective: A variety of measures are used for reporting levels of compulsory psychiatric hospitalisation. This complicates comparisons between studies and makes it hard to establish the extent of geographic variation. We ... -
Measuring the results of quality improvement work
(Prosjektrapport (Norges Byggforskningsinstitutt);155, Research report, 1994) -
Measuring the thermal conductivity of membrane and porous transport layer in proton and anion exchange membrane water electrolyzers for temperature distribution modeling
(Peer reviewed; Journal article, 2019)Water electrolyzers that use a membrane electrolyte between the electrodes are a promising technology towards mass production of renewable hydrogen. High power setups produce a lot of heat which has to be transported through ... -
Measuring β* in SuperKEKB with K modulation
(Peer reviewed; Journal article, 2020)SuperKEKB is an asymmetric energy electron positrion collider currently under commissioning in Japan. It aims to achieve a record high luminosity of 8 × 10 35 cm − 2 s − 1 , for which accurate control of β ∗ y is ... -
Mechanical and durability properties of concrete subjected to early-age freeze–thaw cycles
(Peer reviewed; Journal article, 2021)Early-age frost damage to concrete used in winter construction or in cold environments negatively affects the development of the hydration process and the performance of the concrete, thereby reducing the service life of ... -
Mechanical properties and calculation of model parameters Concrete with Aalborg cement and variable fly ash content
(COIN Project report;56, Research report, 2015)One of the objectives of COIN's Focus Area 3.1 Crackfree concrete structures is to develop guidelines for recommended mix design for different types of structures subjected to restrained thermal dilation and autogeneous ... -
Mechanical properties and calculation of model parametersConcrete with Norcem cement and variable fly ash content.FA: Technical performance. SP 3.1 Crack free concrete structures
(COIN Project report;55, Research report, 2015) -
The mechanical properties of a model hydrogenated nitrile butadiene rubber (HNBR) following simulated sweet oil exposure at elevated temperature and pressure
(Peer reviewed; Journal article, 2015)A typical carbon black reinforced hydrogenated nitrile butadiene rubber (HNBR) was exposed to a mix of hydrocarbons (toluene, heptane and cyclohexane) at elevated temperatures and pressure in order to chemically age the ... -
Mechanical Properties of AlSi10Mg Processed by Laser Powder Bed Fusion at Elevated Temperature
(The Minerals, Metals & Materials Series;2367-1181, Peer reviewed; Journal article, 2020)AlSi10Mg processed by laser powder bed fusion is expected to have remarkable mechanical properties due to the dominant cellular microstructure. However, the as-processed material is often both anisotropic and containing ... -
Mechanical properties of lightweight aggregates
(Journal article; Peer reviewed, 2013)Lightweight aggregates (LWAs) were successfully produced both in a pilot-scale rotary kiln and in a laboratory chamber furnace. The mechanical properties of LWA were investigated in detail applying the European standard ... -
Mechanical reliability analysis of a real network to support the design of Isolation Valve System
(Chapter; Conference object, 2017)The Isolation Valve System (IVS) allows to detach some portions of water distribution networks (WDN) to perform planned (e.g. maintenance) or unplanned (e.g. failures) works. Isolating WDN segments ...