Blar i SINTEF Open på tittel
Viser treff 1672-1691 av 10062
-
Comparison of laboratory wave generation techniques on response of a large monopile in irregular sea
(Peer reviewed; Journal article, 2022)As the offshore wind industry moves toward larger monopile turbines, model testing and validation of hydrodynamic load models become more important for new designs of turbines. Wave generation is an important aspect of ... -
Comparison of Levelized Cost of Energy of superconducting direct drive generators for a 10 MW offshore wind turbine
(Journal article; Peer reviewed, 2018)A method for comparing the Levelized Cost of Energy (LCoE) of different superconducting drive trains is introduced. The properties of a 10 MW MgB$_{2}$ superconducting direct drive generator are presented in terms weight ... -
Comparison Of Membrane-Based Pre- And Post-Combustion CO2 Capture Options Applied In Energy-Intensive Industrial Applications
(Peer reviewed; Journal article, 2023)Deployment of decarbonization technologies in energy-intensive industrial applications (e.g., heat and power, metallurgy, cement, chemical sectors etc.) is of great importance for reducing CO2 emission and achieving global ... -
Comparison of microbial community dynamics induced by distinct crude oil dispersions reveals compositional differences
(Journal article; Peer reviewed, 2018-11)To understand the impact of oil contamination on marine microbial communities, numerous studies have been conducted following microbial dynamics after oil spills and concerning the effects of different environmental ... -
Comparison of Offline VLF PD Measurements and Online PD Measurements on a 50-Year-Old Hydrogenerator Stator in Norway
(Chapter; Peer reviewed, 2018)Stator winding insulation is the part of the hydrogenerator experiencing the highest number and the most damaging failures. Partial discharge (PD) measurement, both offline and online, are commonly used for condition ... -
Comparison of organic and conventional food and food production. Part II: Animal health and welfare in Norway
(VKM Report;22-2, Research report, 2014-04-30) -
COMPARISON OF PARTICLE-RESOLVED DIRECT NUMERICAL SIMULATION AND 1D MODELLING OF CATALYTIC REACTIONS IN A PACKED BED
(Chapter, 2017)The work presents a comparison of catalytic gas-solid reactions in a packed bed as simulated on two widely different scales: direct numerical simulation (capable of accurately predicting transfer phenomena in and around a ... -
Comparison of particle‐resolved direct numerical simulation and 1D modelling of catalytic reactions in a packed bed
(SINTEF Proceedings;2, Chapter; Conference object; Peer reviewed, 2017)The work presents a comparison of catalytic gas-solid reactions in a packed bed as simulated on two widely different scales: direct numerical simulation (capable of accurately predicting transfer phenomena in and around a ... -
Comparison of phenomenological and fundamental modelling approaches for predicting fluidized bed reactor performance
(Peer reviewed; Journal article, 2012)Two approaches to modelling fluidized bed reactors were evaluated and compared in this work: a phenomenological 1D approach based on empirical closures and a more fundamental 2D approach based on computational fluid dynamics ... -
Comparison of predicted properties of Ekofisk oils based on Crude Assay data - Evaluation of the predicted behaviour of satellites relative to previous studies.
(SINTEF reports;A27361, Research report, 2015-12-03) -
Comparison of Rankine cycle and trilateral flash cycle for power production from low temperature heat sources
(Science et technique du froid;2018-3, Chapter; Peer reviewed, 2018) -
Comparison of social and sociodemographic characteristics and treatment goals of persons with alcohol versus drug use disorders: Result from a national census of inpatients in specialized treatment for substance use
(Peer reviewed; Journal article, 2021)Introduction: We examined differences in social and sociodemographic characteristics and treatment goals between people with primary alcohol use disorder (AUD) versus those with a primary drug use disorder receiving ... -
Comparison of Technologies for CO2 Capture from Cement Production — Part 2: Cost Analysis
(Journal article; Peer reviewed, 2019)This paper presents an assessment of the cost performance of CO2 capture technologies when retrofitted to a cement plant: MEA-based absorption, oxyfuel, chilled ammonia-based absorption (Chilled Ammonia Process), ... -
Comparison of Technologies for CO2 Capture from Cement Production—Part 1: Technical Evaluation
(Journal article; Peer reviewed, 2019)A technical evaluation of CO2 capture technologies when retrofitted to a cement plant is performed. The investigated technologies are the oxyfuel process, the chilled ammonia process, membrane-assisted CO2 liquefaction, ... -
Comparison of test method EN 16510-1:2018 with EN-PME test method vs NS 3058-1/2:1994 and NS 3059:1994
(Report - RISE Fire Research;, Research report, 2022) -
Comparison of the condition of steel fiber-reinforced shotcrete with water-glass and alkali-free activators after more than 20 years of service in a subsea road tunnel
(Peer reviewed; Journal article, 2022)The in-service condition of steel fiber-reinforced shotcrete installed more than 20 years ago as single-shell rock support lining in the Nordkapp subsea road tunnel was investigated. The novelty of this study is the ... -
Comparison of the efficiency and modes of capture of biodegradable versus nylon gillnets in the Northeast Atlantic cod (Gadus morhua) fishery
(Peer reviewed; Journal article, 2022) -
Comparison of the greenhouse gas emissions of a high-rise residential building assessed with different national LCA approaches– IEA EBC Annex 72
(Peer reviewed; Journal article, 2020)Introduction: The international research project IEA EBC Annex 72 investigates the life cycle related environmental impacts caused by buildings. The project aims inter alia to harmonise LCA approaches on buildings. Methods: ... -
Comparison of the Transient Behaviors of Bubbling and Circulating Fluidized Bed Combustors
(Peer reviewed; Journal article, 2022) -
Comparison of Three Real-Time Measurement Methods for Airborne Ultrafine Particles in the Silicon Alloy Industry
(Peer reviewed; Journal article, 2016)The aim of this study was to compare the applicability and the correlation between three commercially available instruments capable of detection, quantification, and characterization of ultrafine airborne particulate matter ...