dc.contributor.author | Bunaziv, Ivan | |
dc.contributor.author | Dørum, Cato | |
dc.contributor.author | Nielsen, Steen Erik | |
dc.contributor.author | Suikkanen, Pasi | |
dc.contributor.author | Ren, Xiaobo | |
dc.contributor.author | Nyhus, Bård | |
dc.contributor.author | Eriksson, Magnus Carl Fredrik | |
dc.contributor.author | Akselsen, Odd Magne | |
dc.date.accessioned | 2022-03-24T09:46:36Z | |
dc.date.available | 2022-03-24T09:46:36Z | |
dc.date.created | 2022-01-11T13:00:04Z | |
dc.date.issued | 2021 | |
dc.identifier.citation | IOP Conference Series: Materials Science and Engineering. 2021, 1135 . | en_US |
dc.identifier.issn | 1757-8981 | |
dc.identifier.uri | https://hdl.handle.net/11250/2987267 | |
dc.description.abstract | Deep penetration laser welding is promising in joining thick (> 10 mm) steel sections. Focused laser beam by drilling vapour cavity, the keyhole, generates deep and narrow welds. Full penetration single-pass joining has a persistent problem with root quality where humping is one of the most frequent imperfection. This strongly hampers the use of high-power laser for thick plate welding. A 16 kW disk laser was used for single-pass welding of 15 mm thick plates in a butt joint configuration. Root humping occurred within a wide range of welding parameters. This provides narrow processing window. By adding an arc source to the laser beam process, the tendency of root humping increases. To achieve humping-free welds and consistent root quality over length, a delicate balance of process parameters is required. High heat input (> 0.50 kJ/mm) was positive to achieve a combination of low hardness (< 325 HV) and good Charpy toughness at -50 °C (> 50 J). | en_US |
dc.language.iso | eng | en_US |
dc.publisher | IOP Science | en_US |
dc.rights | Navngivelse 4.0 Internasjonal | * |
dc.rights.uri | http://creativecommons.org/licenses/by/4.0/deed.no | * |
dc.title | Root formation and mechanical properties in laser keyhole welding of 15 mm thick HSLA steel | en_US |
dc.type | Peer reviewed | en_US |
dc.type | Journal article | en_US |
dc.description.version | publishedVersion | en_US |
dc.rights.holder | The Authors. Content from this work may be used under the terms of theCreative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI. Published under licence by IOP Publishing Ltd | en_US |
dc.source.pagenumber | 11 | en_US |
dc.source.volume | 1135 | en_US |
dc.source.journal | IOP Conference Series: Materials Science and Engineering | en_US |
dc.identifier.doi | 10.1088/1757-899x/1135/1/012011 | |
dc.identifier.cristin | 1978319 | |
dc.relation.project | Norges forskningsråd: 309584 | en_US |
dc.source.articlenumber | 012011 | en_US |
cristin.ispublished | true | |
cristin.fulltext | original | |
cristin.qualitycode | 1 | |