Flame spray pyrolysis of electrode materials for energy applications

Dahl, Paul Inge; Thomassen, Magnus Skinlo; Rausseo, Luis César Colmenares; Barnet, Alejandro; Lomas, Scott; Vullum, Per Erik; Hanetho, Sidsel Meli; Mokkelbost, Tommy
Peer reviewed, Journal article
Accepted version
Thumbnail
Åpne
Permanent lenke
https://hdl.handle.net/11250/2720587
Utgivelsesdato
2015
Metadata
Vis full innførsel
Samlinger
Originalversjon
Materials Research Society Symposium Proceedings. 2015, 1747 25-30.   10.1557/opl.2015.340
Sammendrag
Flame spray pyrolysis (FSP) was applied to produce nanopowders of Ti1-xMxO2 and Sn1-xMxO2, where x = 0.05 and M = Nb/Sb, for use as catalyst support materials in PEM fuel cells/ electrolysers. FSP powders in the SnO2-IrO2 system were produced for the same applications. Homogenous particle size distribution (5-20 nm) was demonstrated by TEM, supported by BET and XRD analysis. Whereas two polymorphs were indicated for the Ti-based oxides, the Sb/Nb-doped SnO2 powders were single phase. FSP powders of Mn3O4 intended for supercapacitors were produced and the influence of the precursor/solvent mixtures on the physical and electrochemical properties evaluated.
Utgiver
Cambridge University Press (CUP)
Tidsskrift
Materials Research Society Symposium Proceedings
Opphavsrett
This is the accepted manuscript of the final, published article available, see: https://doi.org/10.1557/opl.2015.340