Blar i SINTEF Industri på emneord "Fatigue"
Viser treff 1-5 av 5
-
High cycle fatigue life estimation of AlSi10Mg processed by laser powder bed fusion
(Journal article, 2018)Fatigue life is known to be dependent on the surface properties of the material. Surface roughness provokes local stress concentration and cause crack initiation even at minute cyclic loads. In laser powder bed fusion, ... -
Multi-scale observation of hydrogen-induced, localized plastic deformation in fatigue-crack propagation in a pure iron
(Peer reviewed; Journal article, 2017)In order to study the influence of hydrogen on plastic deformation behavior in the vicinity of the fatigue crack-tip in a pure iron, a multi-scale observation technique was employed, comprising electron channeling contrast ... -
Multi-scale observation of hydrogen-induced, localized plastic deformation in fatigue-crack propagation in a pure iron
(Peer reviewed; Journal article, 2017)In order to study the influence of hydrogen on plastic deformation behavior in the vicinity of the fatigue crack-tip in a pure iron, a multi-scale observation technique was employed, comprising electron channeling contrast ... -
Subsea power cable sheathing: an investigation of lead fatigue performance
(Peer reviewed; Journal article, 2020)The protection of subsea power cables against electrical failure is achieved by the use of a watertight layer. Due to its properties of chemical stability and ductility, lead has been the material of choice for this purpose ... -
Tensile and fatigue behavior of a Pb-Sn-Sb alloy investigated via small-scale in-situ mechanical testing in SEM
(Journal article; Peer reviewed, 2020)Pb-Sn-Sb alloys (E-alloy) are commonly used in subsea power cable sheathing. Due to the relatively low melting temperature, i.e. around 600 K, this type of alloy is prone to experience microstructural time-dependent evolution ...