Browsing SINTEF Industri by Journals "Journal of Power Sources"
Now showing items 1-11 of 11
-
Comparing electrochemical perormance of transition metal silicate cathodes and chevrel phase Mo6S8 in the analogous rechargeable Mg-ion battery system
(Peer reviewed; Journal article, 2016)Polyanion based silicate materials, MgMSiO4 (M = Fe, Mn, Co), previously reported to be promising cathode materials for Mg-ion batteries, have been re-examined. Both the sol-gel and molten salt methods are employed to ... -
Current status and future perspectives of lithium metal batteries
(Peer reviewed; Journal article, 2020)With the lithium-ion technology approaching its intrinsic limit with graphite-based anodes, Li metal is recently receiving renewed interest from the battery community as potential high capacity anode for next-generation ... -
Experimental review of the performances of protective coatings for interconnects in solid oxide fuel cells
(Peer reviewed; Journal article, 2023)Ferritic stainless steel interconnects are used in solid oxide fuel cells; however, coatings are required to improve their performance. Although several types of coatings have been proposed, they have been scarcely ... -
Inside the electrode: Looking at cycling products in Li/O2 batteries
(Journal article; Peer reviewed, 2019)This work investigates the impact of electrochemical reactions and products on discharge capacity and cycling stability with electrolytes based on two common solvents – tetraethylene glycol dimethyl ether (TEGDME) and ... -
Ionomer content optimization in nickel-iron-based anodes with and without ceria for anion exchange membrane water electrolysis
(Peer reviewed; Journal article, 2021)Hydrogen production from anion exchange membrane water electrolysis (AEMWE) is an efficient cost-effective solution to renewable energy storage. Contrary to proton exchange membrane (PEM) electrolysis, AEMWE requires further ... -
Issues regarding bipolar plate-gas diffusion layer interfacial contact resistance determination
(Peer reviewed; Journal article, 2022)The interfacial contact resistance (ICRBPP-GDL) between the bipolar plates (BPPs) and gas diffusion layers (GDLs) plays a major role in proton exchange membrane-fuel cells (PEMFCs) efficiency. Accordingly, materials selection ... -
Microstructure and electrochemical behavior of layered cathodes for molten carbonate fuel cell
(Peer reviewed; Journal article, 2021)In the present paper, we demonstrate how modifications of the microstructure and the chemical composition can influence the electrochemical behavior of cathodes for molten carbonate fuel cells (MCFCs). Based on our experience, ... -
Microstructure and performance of La0.58Sr0.4Co0.2Fe0.8O3−d cathodes deposited on BaCe0.2Zr0.7Y0.1O3−d by infiltration and spray pyrolysis
(Peer reviewed; Journal article, 2012)La0.58Sr0.4Co0.2Fe0.8O3−d (LSCF) cathodes have been deposited on proton-conducting BaCe0.2Zr0.7Y0.1O3−d (BCZY27) electrolyte and studied in symmetric cells to investigate the cathode microstructure and electrochemical ... -
Online measurements of fluoride ions in proton exchange membrane water electrolysis through ion chromatography
(Peer reviewed; Journal article, 2021)This work investigates the online monitoring of fluoride ion concentration in proton exchange membrane water electrolysers (PEMWE) effluent water using an automated ion chromatography (IC) setup. Prototype catalyst coated ... -
Performance and failure analysis of full cell lithium ion battery with LiNi0.8Co0.15Al0.05O2 and silicon electrodes
(Journal article; Peer reviewed, 2019)The influence of the lithium inventory on the performance and degradation mechanism of NCA||Si cells operating at a third of the theoretical silicon capacity is analysed. The lithium inventory was increased by electrochemical ... -
Silicon anodes for lithium-ion batteries produced from recovered kerf powders
(Peer reviewed; Journal article, 2019)Silicon kerf waste from a photovoltaic silicon production process is assessed as an anode material for application as a lithium ion battery anode. In contrast to previous studies, the Si-kerf is used as-produced, with no ...