Blar i Publikasjoner fra CRIStin - SINTEF Energi på tittel
Viser treff 380-399 av 1632
-
A detailed review on CO2 two-phase ejector flow modeling
(Peer reviewed; Journal article, 2020)Ejector-equipped vapor-compression systems for refrigeration and cooling, relying solely on (R744) as a natural working fluid, are perceived to be an eco-friendly and highly efficient solution for many applications. However, ... -
A Deterministic Breakdown Model for Dielectric Interfaces Subjected to Tangential Electric Field
(Peer reviewed; Journal article, 2021)The contact area between solid insulations, namely solid-solid interfaces, affect the dielectric characteristics of an entire insulation system. With the theoretical and experimental studies covered in this paper, we intend ... -
A Deterministic Model for Contact Surfaces at Dielectric Interfaces Subjected to an Electrical Field
(Conference on Electrical Insulation and Dielectric Phenomena. Annual Report;2020, Chapter; Peer reviewed, 2021) -
Developing a Pilot Case and Modelling the Development of a Large European CO2 Transport Infrastructure -The GATEWAY H2020 Project
(Journal article; Peer reviewed, 2017)The H2020 GATEWAY project aims to develop a comprehensive model Pilot Case which, intentionally, will pave the ground for CCS deployment in Europe. It will result from the assessment of, technical, commercial, judicial and ... -
Developing a wind and solar power data model for Europe with high spatial-temporal resolution
(Chapter; Peer reviewed, 2016) -
Developing a wind and solar power data model for Europe with high spatial-temporal resolution
(Chapter; Peer reviewed, 2016) -
Development and modelling of different decarbonisation scenarios of the European energy system until 2050 as a contribution to achieving the ambitious 1.5°C climate target - Establishment of open source/data modelling in the European H2020 project openENTRANCE
(Peer reviewed; Journal article, 2020)The ambition of the openENTRANCE project is to develop and establish an open, transparent and integrated modelling platform for assessing low-carbon transition pathways of the European energy system. In this context, the ... -
Development and performance mapping of a multi-ejector expansion work recovery pack for R744 vapour compression units
(Peer reviewed; Journal article, 2015)A multi-ejector expansion pack, intended as a substitute for a standard high-pressure electronic expansion valve (HPV), was designed, manufactured and experimentally investigated. Four different ejector cartridges were ... -
Development and validation study of a 1D analytical model for the response of reheat flames to entropy waves
(Peer reviewed; Journal article, 2020)Numerical simulations of laminar premixed flames burning hydrogen and methane in spontaneous ignition mode are performed by harmonically exciting the reactants’ temperature at the domain inlet. The results are compared to ... -
Development of a Generic Future Grid Code regarding Wind Power in Europe
(Chapter, 2017) -
The development of a hydrocarbon high temperature heat pump for waste heat recovery
(Peer reviewed; Journal article, 2019)Waste heat is an abundant resource that if recovered with a heat pump would increase energy efficiency in industrial processes. This will provide improvements in heat utilization and reduce the environmental impact of ... -
Development of a qualitative framework for analysing high-impact low-probability events in power systems
(Chapter; Peer reviewed, 2018)High-Impact Low-Probability (HILP) events in power systems historically involve a multitude of aspects, including diverse and disparate threats, failures and sequences of events. Each of these aspects are associated with ... -
Development of a scale model of a Modular Multilevel Converters
(Peer reviewed; Journal article, 2017)Modular Multilevel Converters are now being introduced in the power grid. Control systems for these converters are complex with many degrees of freedom. Simulation models are useful for exploring control algorithms, but ... -
Development of a spray-ejector condenser for the use in a negative CO2 emission gas power plant
(Peer reviewed; Journal article, 2023)One promising solution for developing low-emission power technologies is using gaseous fuel combustion in pure oxygen when the exhaust gas mixture is composed of H2O and CO2, and where CO2 is separated after steam condensation. ... -
Development of a web-based user-friendly cable ampacity calculation tool
(Journal article; Peer reviewed, 2019) -
Development of an LQR framework for rapid prototyping of offshore wind turbine controllers, with application to active load
(SINTEF Rapport;, Research report, 2020)A linear quadradic regulator (LQR) framework has been developed for rapid prototyping of offshore wind turbine controllers. This enables the study of tradeoffs between conflicting control objectives, such as maximizing ... -
Development of Energy Communities in Europe
(International Conference on the European Energy Market;18, Chapter; Peer reviewed, 2022)This paper presents a review study of energy communities (ECs) in Europe, and discusses the future development of such communities in Europe – both related to energy technologies, energy carriers, regional conditions (North, ... -
Development of small versus large hydropower in Norway– comparison of environmental impacts
(Peer reviewed; Journal article, 2012)This study has compared the accumulated environmental impacts from 27 small-scale hydropower plants with 3 large hydropower projects. The results show a slight tendency that large hydropower has a lower degree of impacts ... -
Development of Smart Grid Standards in View of Energy System Functionalities
(Chapter; Peer reviewed, 2021)A range of technologies must be developed and deployed for achieving a decarbonised energy system. A smart grid aims to integrate these different technologies into a single, over-arching system that is at the same time ... -
Development of smart, low energy input heat pump drying for increased sustainability in organic food chain
(SINTEF Rapport;, Research report, 2021)The quality of a product and sustainability of production depend on the cumulative impacts of each processing step in the food chain and their interplay. The future generation of organic food products will depend on both. ...